Rear Wheel Hub for Chinese ATV or Go-Kart
Version 48
This rear wheel hub is used on several makes and models of Chinese ATVs. The best way to insure you are ordering the correct part is to use our detail pictures and measurements. Please be sure to check both before ordering.
Check distance between bolt holes before ordering!
Hub details:
- 3 mounting holes
- Distance between holes: 78mm [3.06"] center to center
- 23 splines
- Center hole diameter: 24mm [.93"]
- Used with 7" rim
- 100868 13302A1848
Hub is known to fit the Tao Tao ATA110B3, ATA110D, ATA110D1, ATA110F, ATA110F1, ATA110H, ATA125A, ATA125A1, ATA125D, ATA125G and ATA135DU atvs.
Fits the Tao Tao ATK125A, GK110, Jeep Auto and Triton 125 go-karts.
Shipping details:
Do you need your hub fast? If you order before 3:00 pm CST, Monday thru Friday, your order goes out the same day. Free shipping on orders in USA over $100. Excludes Hawaii and Alaska. Buy now!
- Reviews
- Questions
Thank you for submitting a review!
Your input is very much appreciated. Share it with your friends so they can enjoy it too!
- parts
- shipping
- information
- grandsons
- holes
- wheel hub hole
- splines
- axle
- area
- rim bolt holes
Canada
United StatesBest place for Chinese parts
The parts information is very helpful. The inventory is outstanding. Shipping is fast. I was about to junk my grandsons ATV until I found VMC. Thanks everyone.
United StatesQuick shipping
As always right part fast. You have a great shipping department always quick and the right part. Your on line description are very good. Makes it easy to find the right part
Great service
Parts came fast got what I needed and my granddaughter is riding again lol
Chinese ATV Rear Wheel Hub, Version 48
This is a well made wheel hub, it fit the center of the wheel and the rim bolt holes lined up as they should, the splines were exactly what the vehicle needed. I anticipated that there may be modification I would need to make prior to buying this hub. The nice thing is that the splines for the axle go all the way through this wheel hub hole. I did have to drill the holes in the rim larger to accept 10mm bolts and I cut about an Inch or 25.4mm from back side of the splined area where the axle goes through, because it was too long for the axle it was put on.
